Set Up Your Silicone or Wooden Mould on a Perfectly Level Surface

Why Level Matters for Resin Mould Casting

When pouring resin, even the smallest slope can cause uneven thickness, unwanted spillover, or pooled edges. A level surface ensures that the resin settles evenly within the mould, preventing one side becoming thicker than the other—a must for projects like memory boxes, petri art, or coasters. It’s especially important when working with deeper moulds, where imbalances are more obvious and challenging to fix.

Simple Steps for Setting Up Your Mould

• Choose a flat work area: A sturdy, flat table or bench works best. Avoid soft or uneven surfaces that can shift during curing.
• Check level using a spirit level: Place a small spirit level on your work surface and directly atop the mould. Adjust as needed by placing shims, folded cardboard, or similar under the mould until it reads true.
• Secure your mould: If your setup is likely to get bumped, use a dab of tape or non-slip matting underneath to keep the mould perfectly still during the entire curing process.

For all-in-one kits like the Resin Memory Box Complete Epoxy Resin Kit or Petri Resin Art kits, these steps are just as relevant, ensuring your results are as beautiful as the designs you imagine.

When This Matters Most

Setting up on a level surface is essential for any project where a uniform finish is key—such as keepsake boxes, layered jewellery, or perfectly circular coasters. If your piece will be on display or used daily, taking these extra few minutes at the start saves disappointment later.