Step 1: Remove Excess Resin from Your Tools

After completing your resin project, remove as much uncured resin as possible from your brushes, mixing buckets, and any used accessories. Use a gentle scraping motion and avoid harsh abrasives, which can damage your tools and make thorough cleaning more difficult later.

If some resin residue is still sticky or stubborn, lightly dampen a cloth with water before proceeding. Avoid allowing resin to cure on the tools, as cured resin is significantly harder to remove in any washer.

Step 2: Pre-Treat with Degreaser for Best Results

Apply a small amount of Strong Technical Degreaser for Resin Projects – 100% Natural Formula onto surfaces with heavy residue. Gently work the product in using a cloth or soft-bristled brush, and let it sit for several minutes. This step helps dissolve oily or sticky resins and prepares your tools for a more effective machine wash.

Step 3: Arrange Tools Inside the Resinator Washing Machine

Open the Resinator washer and neatly arrange your items so water and cleaning agents can circulate effectively. Place smaller tools and brushes in provided baskets or trays, making sure nothing is stacked or wedged too tightly.

For thorough agitation, agitate harder-to-clean areas with a Reusable Silicone Resin Brush for Epoxy Art and Wood Applications before closing the lid. This helps remove residues from intricate or bristled surfaces.

Step 4: Run the Cleaning Cycle and Finish Up

Add the required amount of water and, if permitted by your washer’s instructions, a dose of natural degreaser to the correct compartment. Close the lid securely and select the recommended cycle for resin tools. Start the machine and wait until the cleaning process is completed.

Once done, open the washer and inspect tools for any missed spots. If necessary, repeat the washing cycle or target remaining residue with spot cleaning using the degreaser. Allow all equipment to air dry completely before storing or reusing.

Cleaning Tips and Troubleshooting

Always use eco-friendly, non-abrasive solutions to protect your tools and extend the life of your equipment. Avoid letting resin cure on brushes or mixing buckets, as this can permanently damage them. If residue remains after one cycle, spot clean using a soft brush and degreaser, then rerun the wash if needed.

Allow tools to dry completely before reuse to ensure no moisture affects future resin pours or finishes.