Free shipping on orders over £29,85 
Shipping Tracking! 
Google
Facebook← Back to How long before I can remove the formwork?
Timing your formwork removal is crucial for a successful epoxy table project. If you’re using EpoxyTable 5, knowing exactly when the resin becomes sturdy enough for handling helps prevent sticky messes and keeps edges crisp and clean.
Understanding EpoxyTable 5 Curing Times
EpoxyTable 5 is formulated for deep pour applications, allowing castings up to 5cm thick with a slow curing cycle to minimise heat build-up and bubbles. Typically, it becomes workable for careful handling and formwork removal after around 72 hours at normal room temperature. The resin continues to harden over the next few days, reaching full cure in approximately 5 to 7 days.
- Demoulding time: About 72 hours from pour.
- Full cure: 5–7 days for maximum hardness and surface resistance.
Practical Tips for Removing Formwork
Before attempting to remove your formwork, double-check the temperature and humidity of your workspace, as cooler or damp conditions can extend curing times. Gently test a corner to see if the resin is solid and does not feel tacky; if in doubt, give it another 12–24 hours. When removing the sides, work slowly to avoid chipping or pulling at the unfinished resin surface. For best results and minimal risk, always follow the guidelines recommended on the EpoxyTable 5-Five product page.
When This Matters Most
Getting the timing right is especially important for projects where edge clarity and a professional finish are key, such as river tables or thick resin pours with intricate details. Rushing to demould too early can result in surface marks or edge damage that are difficult to fix later.
Related products
Related guides
Allowing sufficient curing for EpoxyTable 5 before formwork removal helps achieve the best possible outcome for your resin table or large project. For other resins or faster demoulding options, compare products on the main removal timing guide.