Free shipping on orders over £29,85 
Shipping Tracking! 
Google
Facebook← Back to How to restore a cement resin coating?
Applying new resin over an existing coating can be a practical way to restore a worn surface and extend its service life. Success relies on proper assessment and preparation of the old coating to ensure a strong, lasting bond.
Assessing the Existing Coating
Before applying fresh resin, thoroughly inspect the old coating. The existing layer must be firmly bonded to the substrate and free from cracks, loose patches, or flaking. Any area that shows instability should be completely removed, as resin applied over loose material is likely to fail. Ensure the surface is dry and has no oil, grease, or significant contamination.
Surface Preparation and Application
Once the old coating is secured, clean the area thoroughly using a mild detergent if required, followed by rinsing and drying. Mechanically abrade glossy or non-absorbent finishes with light sanding to aid resin adhesion. After preparation, you can apply a compatible product – such as Resinstone for absorbent concrete, or Prolux PU coating for other surfaces like ceramic, plastic, or prepared steel – always following the specific instructions for mixing and curing.
When This Matters Most
Recoating is especially relevant when restoring driveways, patios, garages, or high-traffic paths where the underlying resin has dulled but is still structurally sound. Proper preparation can breathe new life into tired areas and save the cost and disruption of full removal and relaying.
Related products
Related guides
Taking time with assessment and preparation is key for effective results when applying resin over existing coatings. For more guidance on restoring cement resin coatings, see our main restoration guide.