Can I Use Photos in Resin Pendants?

Choosing and Preparing Your Photo

Select a high-quality image and print it using a UV-stable ink to help reduce fading over time. Laser prints typically perform better than inkjet, as they are less likely to bleed. Always trim your photo to fit the pendant mould and make sure it is completely flat before sealing.

• Print on smooth, non-porous paper if possible.
• Water-based inks should be avoided unless fully sealed.

Sealing Photos for Resin Embedding

Before embedding your photo, it’s vital to seal it thoroughly on both sides to prevent any resin from soaking in, which can cause blurring or discolouration. Use a clear-drying adhesive, decoupage glue, or a specialist photo sealant—apply thin coats and let each layer dry fully.

Only place your sealed image into resin after allowing ample drying time to ensure the best clarity and edge definition.

Pouring Resin: Practical Guidance

Opt for a transparent, high-quality resin to showcase your image. Products like the Evershine Collection Epoxy Resin Kit offer crystal-clear finishes ideal for encapsulating detailed photos. Mix according to the instructions—typically a straightforward 1:1 ratio for many jewellery resins—then pour slowly to avoid bubbles. Use a toothpick to gently position the image and remove trapped air.

Allow the piece to cure fully before demoulding for a flaw-free result.