“EpoxyWood” – Wood Restoration Epoxy Resin for Deep Penetration and Waterproofing

Technical data – “EPOXYWOOD” – Epoxy Resin for Wood:

• Mix ratio: 2:1 by weight/ 100:50 by weight
• Working life: 150 gr at 20°C: 30 ′
• Viscosity of part A: 800 ± 120 mPa·s (20°C)
• Viscosity of part B: 300 ± 100 mPa·s (20°C)
• Hardness: Shore D 80 EN ISO 868
• Full catalysis: 7 days
• Demoulding time: 12-24h
• Film catalysis: (1.5 mm at 30°C) [0,05” at 86 F]: 6h
• Maximum pouring level: 1.5cm*
• Minimum pouring level: 1.5mm
• Heat resistance: up to 70°C
• Coverage 1kg: 100*60*0.15cm
• 1sqm consumption (1.5mm thickness): 5kg
• Colour: Straw-yellow

Download SDS (Part A)
Download SDS (Part B)
Download TDS

Tips for use:

• Respect the usage ratio and mix thoroughly for at least 3 minutes. Once the mixture is ready, apply it within 30 minutes.
• Before applying “EPOXYWOOD”, ensure that the surface to be treated is perfectly dry and moisture-free.
• Storage temperature: 10-30°C [50-86 F]. At low temperatures it can crystallize. To restore it, warm it up in a bain-marie or in boiling water. Reuse when cooled

For best results, measure two components based on weight using a scale within 5% of the recommended mix ratio.

• Always mix the product thoroughly for at least 2 minutes, scraping all the surfaces of the container to ensure complete mixing.
• Try to use the product in a temperature-controlled environment within the optimal product specifications.
• Avoid high humidity or low ambient temperatures.
• Ensure that the surface is dry and any dirt, dust and oils removed to achieve optimal bonding. It is furthermore highly recommended to sand the surface (with sandpaper or mechanical preparation).
• Perform small preliminary tests to have a clear understanding of the polymerization features of the resins in your work environment and the compatibility of the resins with other materials.
• When creating a coating with epoxy resin, do not fill the mixture with a thickness of less than 1.5-2 mm, otherwise, after curing, there is a chance of shrinkage with the formation of “craters” – small depressions on all surfaces of the fill.

if you have not enough experience, we insistly suggest to make a small test before working with large project.

WARNINGS:
During processing, use protective masks, gloves, and other protective clothing.
In case of contact with eyes, immediately rinse with cold water for 15 minutes and immediately consult a doctor.